David Witton's Discussions (241)

Search Forum

View

Discussions Replied To (235) Replies Latest Activity

"Well, the chine caps are on - it was a bit of a wrestling match. They're 2 1/4" wide…"

David Witton replied Dec 17, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"They do - and unlike the frames, they sit WAY off the vertical, so you need to take…"

David Witton replied Dec 16, 2015 to Chine Notch Questions

 4 Jan 18, 2016
Reply by Brad Dimock

"Mike The bottom consists of four layers of material - first, 1/4" meranti plywood sc…"

David Witton replied Dec 15, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"I should have been more clear - I had planned to coat them with epoxy to seal them,…"

David Witton replied Dec 13, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"I"m at the point where I'm doing a first install of the chine caps - I'll take them…"

David Witton replied Dec 13, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"That detail is an oversized Federalist banding - I just cut out a whole bunch of dia…"

David Witton replied Dec 13, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"This is  my first boat, so I'm learning all sort of things - like how the build goes…"

David Witton replied Dec 12, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"Mike - Aside from tipping with a foam brush, do you worry about bubbles? What do you…"

David Witton replied Dec 6, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"Next step is adding a couple of coats of epoxy to the outside of the hull - of cours…"

David Witton replied Dec 6, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"Mike - here's a shot of the bottom.  I suppose it would have been smoother if I'd u…"

David Witton replied Dec 6, 2015 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service