Bennett Yarbrough's Discussions (363)

Discussions Replied To (347) Replies Latest Activity

"Been slowly building up the chine where I tried to make material that was 1/8" too n…"

Bennett Yarbrough replied Feb 19, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"clamp condoms again"

Bennett Yarbrough replied Feb 10, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"You can see in this picture how I set the outside of the chine flush with the side…"

Bennett Yarbrough replied Feb 10, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"Installed my chines too low. I intentionally didnt cut the top bevel on the chine lo…"

Bennett Yarbrough replied Feb 10, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

" "

Bennett Yarbrough replied Feb 8, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"thanks David, I'm thinking I'll just run the anchor dead center and if I need to put…"

Bennett Yarbrough replied Feb 8, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

" got my bottom pretty well faired with this torture device"

Bennett Yarbrough replied Feb 8, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"Thanks mike. So do most people just drill the hole for the rope dead center on the t…"

Bennett Yarbrough replied Feb 2, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"this is what I was thinking in terms of the anchor rope routing.  Blue would be for…"

Bennett Yarbrough replied Feb 2, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

"So now I'm ready to prep for the bottom, but I do have a few questions that I couldn…"

Bennett Yarbrough replied Feb 2, 2017 to Baker 17x54 build

295 Oct 1, 2023
Reply by Bennett Yarbrough

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service