I am working on prefinishing frames before assembling the hull of my boat. I plan to use a floor mounted anchor release and route the anchor line though conduit run through the horizontal frame members. No surprises there. I dont have my anchor release yet but wish to drill the frames for the conduit. Any help on how far up off the bottom of the frames those holes should be drilled? Likely I will use a piece of oak stock finished 3/4 or 1 inch thick to mount the release mechanism between the frames. Thanks

Views: 240

Reply to This

Replies to This Discussion

I did mine dead center/maybe a 1/4 inch high.  For reference, I have a Regal pedal mounted on 1/2 thick board.  Everything lines up perfect.  I did wait until the frames were installed to drill my holes though so I could pull a rope in the area and see how best to line up the holes vs drilling them all in the same location with regards to the floor.  Hope that makes sense.

Sounds like predrilling is not really critical. 

It’s not.  But it is important that you do it before installing the bottom.

JC,

If you need help getting a system I can get you one.

Mike

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service