Comments - chines bubbles?? - Wooden Boat People2024-03-29T08:23:21Zhttp://woodenboatpeople.org/profiles/comment/feed?attachedTo=1312281%3ABlogPost%3A34695&xn_auth=noRick's comments about the rou…tag:woodenboatpeople.org,2010-11-06:1312281:Comment:356462010-11-06T14:58:20.251Zlhedrickhttp://woodenboatpeople.org/profile/lhedrick
Rick's comments about the rounded surface are important. If you try to glass over a sharp edge the glass will lift and air will get under it.<br />
<br />
All you need to do is use a sharp utility knife and cut the glass, then work thickened epoxy under it, cover with plastic and tape over it to hold it down. Small bubble are no big deal. You can always cut out the bubble all together and just fill it. If you have a large section which has lifted up then cut it out and cut a piece of glass to go in the…
Rick's comments about the rounded surface are important. If you try to glass over a sharp edge the glass will lift and air will get under it.<br />
<br />
All you need to do is use a sharp utility knife and cut the glass, then work thickened epoxy under it, cover with plastic and tape over it to hold it down. Small bubble are no big deal. You can always cut out the bubble all together and just fill it. If you have a large section which has lifted up then cut it out and cut a piece of glass to go in the space. then put another layer of glass over that the next day.<br />
<br />
This happens a lot and its minor. Are you rounding the edge whe…tag:woodenboatpeople.org,2010-10-27:1312281:Comment:349302010-10-27T20:31:39.556ZRick Newmanhttp://woodenboatpeople.org/profile/RickNewman
Are you rounding the edge where you are putting on the epoxy? I am presuming you are also putting fiberglass tape of cloth over the edge. A rounded edge allows the epoxied glass to conform to the substrate while a squared edge can result in voids or "bubbles" because the fabric doesn't follow the square edges. Perhaps this is what is happening. Can you post pictures?<br />
<br />
Rick Newman
Are you rounding the edge where you are putting on the epoxy? I am presuming you are also putting fiberglass tape of cloth over the edge. A rounded edge allows the epoxied glass to conform to the substrate while a squared edge can result in voids or "bubbles" because the fabric doesn't follow the square edges. Perhaps this is what is happening. Can you post pictures?<br />
<br />
Rick Newman