A couple of seats

I wanted to post a couple of seats I have built so far waiting on panels to cure on the garage floor.  I want to thank Scott Helper for getting me the ideas on these to start, and the crew at Montana Boat Builders who really really hooked me up on the designs.  Hope you enjoy, and yes these are made from fir, not oak.

 

Views: 572

▶ Reply to This

Replies to This Discussion

Permalink Reply by Greg Hatten on March 12, 2011 at 1:11pm

Very nice work Jordon.  Love that seat design - can't wait to see the finished product!!

GH

Permalink Reply by Lawrence E. Long on March 13, 2011 at 5:05am

Nice work Jordan- one suggestion( if you have done it and we can't see them)- drill drain holes in each of the bottom panel corners so water can get out. Rain, waders, Labrador Retrievers etc.

Good Luck

Permalink Reply by Jordan Davis on March 13, 2011 at 12:16pm
Thanks for the advice.  I had planned on it!

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service