Sawyer wood and fiberglass oars question

Hi, I bought a pair of sawyer 9' oars that need to have the handle replaced in one of them. Are there any instructions on how to do this properly? I also don't really know where to go to get the replacement handle. It slips inside the fiberglass shaft and over a smaller inner core. Any suggestions would be greatly appreciated. Thanks.

Views: 208

▶ Reply to This

Replies to This Discussion

Permalink Reply by Mike Dearing on July 24, 2009 at 7:17am
Just contact Sawyer (541 535 3606) and tell them exactly what oars you have, they can send you a new handle. Sometimes they have a little silicone around the top of the grip, but other then that you just have to remove the set screw and pull the handle out.

Mike
Permalink Reply by Bryan McDade on July 24, 2009 at 3:06pm
Thank You I really appreciate you help

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service