Stem/Stern post material

Any advice would be great! Im stuck trying to figure out what to use for making my stem and stern posts. I want to use a 3"x 6" stock of white oak to cut them out of, for a final dimension of 2 1/2" x 5". But, I cannot find anything more than 2" thick. Is it acceptable to laminate two 2x6 pieces and fabricate from that? Or...is it okay to just make them a little skinnier (from 2x6 stock). I want to stick with the white oak to match the caps, rails, and chine.

Views: 173

▶ Reply to This

Replies to This Discussion

Permalink Reply by Jon Carter on April 22, 2009 at 11:05am
Laminating two pieces together will actually be stronger than one piece and less subject to warping or cracking. Others more knowledgeable in boat building will need to reply on using narrower stock. I am surprised you can't find thick enough stock. Even here in Boise we have a place that specializes in hardwood and is willing to cut to size if required.
Permalink Reply by Adam S. on April 22, 2009 at 7:39pm
Thanks Jon. Ill have to do some more digging and asking around in my area. Good point about the advantages of laminating compared to one big hunk of wood.
Permalink Reply by Dave Z on April 23, 2009 at 12:58pm
Laminating is just fine. I've done it before.

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service