Mike Thomas's Discussions (471)

Search Forum

View

Discussions Replied To (459) Replies Latest Activity

"had to use the kitchen table for a epoxy bench last night, fired up the woodstove an…"

Mike Thomas replied Feb 2, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

"I`m going with the height I have worked out. I can get the oars out of the water, ye…"

Mike Thomas replied Jan 31, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

"The way it looks, I`ll have the seat too low once I notch the seat rails onto the pi…"

Mike Thomas replied Jan 29, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

"I just saw a pic on there looking through old threads doing some searches, guy used…"

Mike Thomas replied Jan 28, 2016 to Anchors

 19 Jan 30, 2016
Reply by David Witton

"Cant be blk pipe, couldnt have got it into the frames. Slick looking set up though.…"

Mike Thomas replied Jan 28, 2016 to drift boat anchor system

 16 Feb 1, 2016
Reply by Rick Newman

"Ive been trying to think back, its been alot of years, the more I think about it, I…"

Mike Thomas replied Jan 27, 2016 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"I used 3/8 ply with good support on the sides and a support pc across the back of th…"

Mike Thomas replied Jan 25, 2016 to 16' Double ender w/ transom

 181 Jul 26, 2021
Reply by David Witton

"So 4" more drop will put it at 16" off the bottom of the boat. Should work. Does any…"

Mike Thomas replied Jan 25, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

"Right now the bench supports are not notched out, that will lower them 1 1/2"-2" may…"

Mike Thomas replied Jan 25, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

"I guess I need a mock up oar lock block and some locks, then I can get this figured…"

Mike Thomas replied Jan 25, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service