Dave Z's Discussions (650)

Discussions Replied To (596) Replies Latest Activity

"Don't skimp on the chine log. Cornerstone of the hull. Find a sawmill that makes h…"

Dave Z replied May 20, 2010 to Chopped Trapper

3 May 20, 2010
Reply by Dave Z

"1/2" or 5/8" white oak, not pre-bevelled, Sika 291, #10 x 1-1/4" si bronze screws. D…"

Dave Z replied May 20, 2010 to Bumper Rail Installation

15 May 20, 2010
Reply by Lawrence E. Long

"Roger, Props to Doug for the donation. For the record, I jumped at the chance to wo…"

Dave Z replied May 18, 2010 to Doug, Dave, et al

1 May 18, 2010
Reply by Dave Z

"What breaks- 1. We broke a bottom frame member once after a particularily bad hit.…"

Dave Z replied May 18, 2010 to Slightly stretching a Trapper

6 May 18, 2010
Reply by Rick Newman

"It looks good. I am not sure, and roger may be able to clarify but I believe the ori…"

Dave Z replied May 16, 2010 to Slightly stretching a Trapper

6 May 18, 2010
Reply by Rick Newman

"keep it light with zero or plywood floorboards. You're ok- 4 degrees? no sweat. You…"

Dave Z replied May 13, 2010 to Trapper frame #6 question.

7 May 17, 2010
Reply by Lee Pendergrast

"Troy, definitely a 9."

Dave Z replied May 12, 2010 to Trapper frame #6 question.

7 May 17, 2010
Reply by Lee Pendergrast

"Troy, When you say "measure" are you measuring the drawing in the book? I don't hav…"

Dave Z replied May 12, 2010 to Trapper frame #6 question.

7 May 17, 2010
Reply by Lee Pendergrast

"Awesome Post AJ. Your wisdom and ability to wade through and sort us all out is spot…"

Dave Z replied May 1, 2010 to Oil Finish 101 ( for stitch and glue guys)

19 May 14, 2010
Reply by Rick Newman

"Mark, It is going to happen again. You are right on- I didn't realize the outside w…"

Dave Z replied Apr 28, 2010 to What would Dave Do?

17 May 1, 2010
Reply by mark hilbert

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service