Lawrence E. Long's Discussions (60)

Search Forum

View

Discussions Replied To (59) Replies Latest Activity

"DZ and MB are on the mark- Scarf your own sheets- Get some practice on scraps before…"

Lawrence E. Long replied Feb 24, 2010 to Scarfing

 6 Feb 24, 2010
Reply by lhedrick

"Don't know- haven't seen any off shore- but that may be a possibility . A dog or pis…"

Lawrence E. Long replied Feb 21, 2010 to Question: How to wrap oarlocks?

 54 Feb 23, 2011
Reply by Rick Newman

"Go to your butcher and get a little tallow. Melt it in a frying pan and slather it o…"

Lawrence E. Long replied Feb 21, 2010 to Question: How to wrap oarlocks?

 54 Feb 23, 2011
Reply by Rick Newman

"Matt: Circular saw is fine for cutting panels- blade just cutting through PW.- Also…"

Lawrence E. Long replied Feb 20, 2010 to Cutting Techniques

 6 Feb 20, 2010
Reply by M Quinlan

"AJ is on the mark!"

Lawrence E. Long replied Feb 17, 2010 to Alternatives to white oak for handrails, chines, etc??

 12 Feb 19, 2010
Reply by Kelly Neu

"Tie in turks head knots-show off your skills"

Lawrence E. Long replied Feb 17, 2010 to Rubber oar stops how to ?

 7 Feb 18, 2010
Reply by Rick Finnell

"A true becket is spliced- or rather relaid. Take a section of 3 strand line about 4…"

Lawrence E. Long replied Feb 17, 2010 to Salt Water and Oiled Boats

 12 Feb 17, 2010
Reply by Lawrence E. Long

"Brad: absolutly a classic piece of craftsmanship! Now then, I have to ask- is the be…"

Lawrence E. Long replied Feb 17, 2010 to Salt Water and Oiled Boats

 12 Feb 17, 2010
Reply by Lawrence E. Long

"Check to see if Bondo is polyester resin- might not be compatible with epoxy or with…"

Lawrence E. Long replied Feb 11, 2010 to Bondo for fairing??

 8 May 14, 2010
Reply by Kelly Neu

"Yes: I asume you mean linseed oil, terpentine, pine tar and japan drier. This mixtur…"

Lawrence E. Long replied Feb 11, 2010 to Salt Water and Oiled Boats

 12 Feb 17, 2010
Reply by Lawrence E. Long

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service