Humidity?

We are having an incredibly wet summer. Rained 20 days in June, July is just as bad if not worst. Rain predicted everyday for the next week. I want to start varnishing the boat but am concerned about having the finish end up cloudy. Have read post about such results. Is there a humidity level that is the cut off point for varnishing? I have a coat of epoxy on the hull inside and out but it has been sanded through in places (fitting bottom ect.).

Views: 74

▶ Reply to This

Replies to This Discussion

Permalink Reply by Jason Knight on July 20, 2009 at 8:20am
Brightwork by Rebecca Wittman
I used that book as a reference for determining good days/temps/times to varnish...
I lucked out and had some relatively cool dry days this spring though that I just knew were fine to varnish..
If it feels too muggy - it probably is.
Permalink Reply by PATRICK M CLEAREY on July 20, 2009 at 5:34pm
Hey Jason. Cleared off Sunday so got the second coat of epoxy on the sides. Started finishing the seats. Unusal summer. We don't usually get this much rain. Good for the trout. Haven't been fishing, Only had the flyrod out twice. Just the boat. Did take a long walk in my woods with the Otsego County Land Trust. Going to put my land in the trust. Saw a vulture nest. For two years they've had chicks under my cabin. Note the "Food" on the ground.


RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service