Comment

Comment by Derek Kellenbeck on September 9, 2015 at 8:27pm

Matt, Your welcome. The main reason I went with this blade to start with was I didn't want to mess up my finish blade. It is defiantly not the funnest part of a boat build.

Comment by Matt Zinkgraf on September 2, 2015 at 11:15am

Thanks for the photo, it was a huge help! I started with a 1/8 kerf finish blade but it was chipping/tearing the rubber really bad.  Then I remembered seeing this photo, the thin kerf circular saw blade did the trick and left clean cuts with no more chipping.

Thanks

Matt