Sort by: View
Discussions | Replies | Latest Activity |
---|---|---|
Middle Fork in late September?Hey, a friend just pulled a permit for the Middle Fork in late September with a 9/29 launch date, so several of us are planning a trip. Mos… Started by Jack Rose in General Forum |
24 |
Feb 9, 2015 Reply by Rick Newman |
OarsI have been reading through the "oar length" posts in the archives. The boat I am building is a 16' x 48" Don Hill. The formula's put me at… Started by John Ahlbin in General Forum |
0 | Feb 8, 2015 |
Scaling down a Briggs/Colorado River DoryHi everyone, Hopefully this topic hasn't been beaten to death previously but I'm thinking of building a scaled down version of Jerry Bri… Started by Craig Campbell in General Forum |
7 |
Feb 7, 2015 Reply by lhedrick |
Epifanes VarnishDoes anyone have experience with Epifanes "no sanding needed" Woodfinish Gloss varnish on West System epoxy coated plywood? Due to the dro… Started by Austin Waggoner in General Forum |
12 |
Feb 6, 2015 Reply by Mike Baker |
teflonAnother thing I have tried to investigate is adding teflon to the bottom epoxy coating rather than graphite. I have tried a few times to fi… Started by Bob bryan in General Forum |
2 |
Feb 6, 2015 Reply by Bob bryan |
mixing epoxy brandsHas anyone ever tried mixing up resin & hardener from different sources? I have system three, raka & Mas in varying amounts both re… Started by Bob bryan in General Forum |
2 |
Feb 6, 2015 Reply by tungsten |
System 200 epoxy resinHowdy, I am in preparation mode to stat building my first drift boat. I have been doing a lot of research and was just curious. Has anyone… Started by Larry Parsons in General Forum |
6 |
Feb 4, 2015 Reply by Larry Parsons |
Chine notches and Chine LogsI am currently building a mckenzie double ender with a transom from Roger Fletchers book. I cut the chine notches in the following way, and… Started by Joe Pruiett in General Forum |
3 |
Feb 2, 2015 Reply by Rick Newman |
what wood besides white oak for outside chine?I have to replace the chines on my boat ...my fault since when I took the UHMW off the bottom and replaced it with epoxy/graphite (huge mis… Started by Bob bryan in General Forum |
4 |
Feb 1, 2015 Reply by Richard |
wood vs aluminumHere's a question; Is there a different feeling in rowing an aluminum dory vs a wood dory? (Specifically a briggs.) There certainly is a di… Started by joe nielson in General Forum |
3 |
Jan 31, 2015 Reply by lhedrick |
© 2024 Created by Randy Dersham. Powered by