Mike Thomas's Discussions (471)

Search Forum

View

Discussions Replied To (459) Replies Latest Activity

"Shute ran out of time to edit. Heres rift sawn white oak on the seat bench frt cross…"

Mike Thomas replied Jun 25, 2016 to Rapid Robert

 12 Jul 6, 2016
Reply by dreu patterson

"Thats rift sawn, not kerf, on the oak, not sure what I was thinking. I got all my DF…"

Mike Thomas replied Jun 25, 2016 to Rapid Robert

 12 Jul 6, 2016
Reply by dreu patterson

"All you can do is try a spot. If it gets splintery I would just belt sand it, but I`…"

Mike Thomas replied Jun 24, 2016 to How to trim the hull on our resto project?

 6 Jun 24, 2016
Reply by Mike Thomas

"Adding in this note on the oar wraps. DO NOT USE the super glass 2 sided tape I used…"

Mike Thomas replied Jun 23, 2016 to Mike`s Framed Drift Boat Build

 315 Jun 23, 2016
Reply by Mike Thomas

"Kerf sawn white oak has a nice straight grain and bends nicer than quarter sawn, but…"

Mike Thomas replied Jun 23, 2016 to Rapid Robert

 12 Jul 6, 2016
Reply by dreu patterson

"Just to add, when you cut the sides over the outside rail, leave yourself a 1/16"-1/…"

Mike Thomas replied Jun 23, 2016 to How to trim the hull on our resto project?

 6 Jun 24, 2016
Reply by Mike Thomas

"Ya, the price is right for me, but the guy said these motors are bad for smoking. I…"

Mike Thomas replied Jun 22, 2016 to Old longshaft motor

 4 Jun 23, 2016
Reply by Greg Hall

"I think what I might do is run the outside top rails, clamping it off all the way to…"

Mike Thomas replied Jun 22, 2016 to How to trim the hull on our resto project?

 6 Jun 24, 2016
Reply by Mike Thomas

"The boat in the first post is a stitch and glue, has a little more freedom being all…"

Mike Thomas replied Jun 21, 2016 to Rear Casting Brace - Gunnel to Gunnel

 17 Jul 6, 2016
Reply by Mark A. York

"Thanks, some years of trim carpentry came in handy. I was trying to find where I had…"

Mike Thomas replied Jun 19, 2016 to Drift Boat Project #3

 135 Jul 31, 2020
Reply by CWarmouth

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service