David Witton's Discussions (212)

Discussions Replied To (206) Replies Latest Activity

"I use a 3.5 HP long shaft Tohatsu on my drift boat - it fits on a wooden bracket tha…"

David Witton replied May 12 to Dorf's Wooden Drift Boat

328 May 13
Reply by craig curtis

"The round holes are for the holddowns - they are scattered on the bench top and side…"

David Witton replied Apr 17 to Staying Alive at Home

19 yesterday
Reply by Peter Honsberger

"It's kinda strange - I did without a "woodworker's" bench until I was 70 - built thi…"

David Witton replied Apr 16 to Staying Alive at Home

19 yesterday
Reply by Peter Honsberger

"We had secured starts on the San Juan and the Smith, but everything went south when…"

David Witton replied Apr 16 to Staying Alive at Home

19 yesterday
Reply by Peter Honsberger

"I'm familiar with Resorcinol, another urea formaldehyde product. Unlike epoxy, it re…"

David Witton replied Feb 8 to Urea formaldehyde for scarfing plywood?

1 Feb 8
Reply by David Witton

"It's a double ender with a transom, straight out of Roger Fletcher's book Drift Boat…"

David Witton replied Dec 26, 2019 to I have a Ply/Epoxy boat but am curious

20 Dec 26, 2019
Reply by Don Tyson

"Don - Here's the sequence I followed: 1. Install each frame and the transom, securin…"

David Witton replied Dec 24, 2019 to I have a Ply/Epoxy boat but am curious

20 Dec 26, 2019
Reply by Don Tyson

"When I built my McKenzie boat I fastened the sides to the frames with thickened epox…"

David Witton replied Dec 21, 2019 to I have a Ply/Epoxy boat but am curious

20 Dec 26, 2019
Reply by Don Tyson

"One approach that hasn't been mentioned in this thread is the combination of plywood…"

David Witton replied Dec 12, 2019 to First build

114 Apr 24
Reply by Dusty

"You have summed up the two schools of thought in your post - I'm in agreement with t…"

David Witton replied Dec 6, 2019 to First build

114 Apr 24
Reply by Dusty

RSS

© 2020   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service