Thomas Hood
  • Male
  • Grants Pass, OR
  • United States
Share on Facebook MySpace

Thomas Hood's Friends

  • Guy Fredrickson
  • Mark Heskett
  • Ross Duncan

Thomas Hood's Discussions

Boot Holes
2 Replies

Quick question, how far in front of your rowing seat did you cut the flat part (where you are bracing) of your boot holes?  I screwed up and put them too far forward my first time.  I'm 6ft if that…Continue

Started this discussion. Last reply by Bennett Yarbrough Apr 10, 2019.

Project finally finished
3 Replies

After a couple years of working on this off and on I can finally say that I am finally finished with my boat and oars.  Took  a lot of trial and error on a few things since I have never been able to…Continue

Started this discussion. Last reply by Thomas Hood Apr 23, 2018.

Sliding Front Seat
2 Replies

Hi, I am building the double ender with transom out of Mr. Fletchers book.  I was wanting to do the sliding front seat.  Can anyone who has done this give me the measurement of how high the rails are…Continue

Started this discussion. Last reply by Thomas Hood Feb 5, 2018.

Restoration or new build
17 Replies

Hi all I have a few questions for you.  I have been wanting to start a new build on the Rogue Dory in Rogers book for a couple years now.  Recently I ran across a Rogue River Special and trailer for…Continue

Started this discussion. Last reply by Don Hanson Oct 17, 2012.

 

Thomas Hood's Page

Latest Activity

Bennett Yarbrough replied to Thomas Hood's discussion Boot Holes
"I didn’t do any cut outs but my floor boards stop at the 6 frame. I’m 6 feet tall and put my feet on the 6 frame when getting after it. Seat is higher than recommended at 16 3/4. I have the tall regal oarlocks with the spacers"
Apr 10, 2019
Kurt Selisch replied to Thomas Hood's discussion Boot Holes
"Sit on the oarsman seat with your knees slightly bent. Mark where your heals are. That should be the spot."
Apr 10, 2019

Profile Information

Hometown:
Grants Pass

Comment Wall (1 comment)

You need to be a member of Wooden Boat People to add comments!

Join Wooden Boat People

At 4:14am on February 23, 2012, Ross Duncan said…

My boats have all been hybreds

I just add stiffeners to the bottom and if you want to the sides.

 
 
 

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service