Wooden Boat People
By McKenzieDriftBoat.com
Boat Building Questions
Getting materials together for a boat now... and have a few questions.
1. It shows to cut the oak stem like a triangle... 3-3/4" on the back side and then 45-degree each of the other two sides. That leaves a sharp point on the end, is this the best way to build a stem?
2. What size/length silicon bronze screws are needed to build the boat?
3. The plans show a 3/4" plywood transom, but my plywood will be 1/4" Meranti on the sides and probably the transom to have the same plywood all around the boat... any ideas?
Thanks for your help...
Views: 159
Replies to This Discussion
-
Permalink Reply by lhedrick on
-
You can dado out the sides of the triangle to make the plywood flush. There is also the option of planing down the point so it's about 1 inch wide and flat. It could also be ripped down on a table saw. Run the plywood sides up to the flat edge then cut a cap to cover the stem and the end grain of the plywood.
You might need an assortment of screws, sizes and lengths. I don't use any screws so I don't have a good idea of the sizes which would be useful.
I just put a transom together a few weeks ago. I had 3/8 so I just laminated 2 layers with epoxy to get 3/4.
-
Permalink Reply by Kelly Neu on
-
My transom was 3/4".
I think 1/4" would flex too much and you'd run the risk of loosing your hull shape.
An eyebolt would pull right through the 1/4" if loaded.
-
Permalink Reply by Riverman on
-
I did not mean to use 1/4" only on the transom... just wondered how to glue it to a 3/4 plywood backing.
-
Permalink Reply by Randy Dersham on
-
1. the older boat plans have a point on the stem. Once the sides are attached you can plane the sides and the point down to a reasonable width and then add a false stem or stem batten to cover the plywood edge grain. It is best to have the finished width be at least 1 inch so you can attach rings or eyebolts.
2. If you don't want to get too crazy with different screw sizes you can standardize on 1" #8. If you need to reach into the wood to get a good grip just counter sink a little deeper and then plug. If you want to not have plugs then you will need a number of different screws from 1" to 1 1/2 inch.
3. You can glue up a transom with epoxy or you can purchase 3/4 in Meranti. It's ok to go to 1" on the transom. Larger will cause some weight problems. Smaller than 3/4 will not support anchors etc.
It looks like you might have a fir transom. You can laminate the 1/4 in Meranti to the 3/4 transom with any good laminating epoxy. I use System Three Silver Tip for all my laminating.
© 2024 Created by Randy Dersham.
Powered by
