Plywood Blade

Hey guys,
Can anyone recommend a decent blade for cutting down some sheets of marine ply? Did some searching online but got a bit overwhelmed. I was planning on using my table saw to do the cutting unless there is an advantage to using a circular instead. Let me know what blades you guys are using.

Also, any recommendations for a decent general purpose blade for cutting frames, etc.? I still have my stock blade in the table saw and it leaves as less than desirable ripped edge.

Thanks!
Jason

Views: 586

▶ Reply to This

Replies to This Discussion

Permalink Reply by Jason Knight on March 18, 2013 at 5:27pm
Jayson,
My Orion blade just arrived. I will give it a test run this week. Feels like a really sturdy blade body. Thanks for the recommendation.
Permalink Reply by Jayson Hayes on March 19, 2013 at 5:23am

did you end up getting it from a local source or did you have to order it? hope you like it! i have about 10 of them and in 10 years havent had to replace one yet.

Permalink Reply by Jason Knight on March 19, 2013 at 5:34am

I ordered it from an online dealer out of GA. I actually called Skarpaz and they gave me a list of vendors. The price seemed really reasonable as well.

Permalink Reply by Phillip Westendorf on March 27, 2013 at 7:48pm

Jason,

Mind sharing the supplier's contact info.  I am interested in purchasing a 80 tooth blade, also.

 

phil w.

Permalink Reply by Rick Newman on March 27, 2013 at 7:58pm

Phil, go back to the first page. It's there.

Rick

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service