Wooden Boat People
By McKenzieDriftBoat.com
Forum Discussions (2,013)
| Discussions | Replies | Latest Activity |
|---|---|---|
How to repair plywood side of 16ft drift boat when boat rolled over lead anchor in thunderstorm on DeschutesSide of 16 ft drift was punched in after boat flew out of water in thunderstorm on June 4. and rolled over lead anchor. The outside will be… Started by Steve Siler in General Forum |
5 |
Jun 24, 2009 Reply by Steve Siler |
Considering Selling My Wood BoatI built a Tatman 17' boat in the early 1990's. I've used it maybe 10 times since. I'd consider it in excellent condition. It also has a nic… Started by Mike O'Connor in General Forum |
6 |
Jun 23, 2009 Reply by Jesse Ronnow |
Oar size AgainI have read the discussions of April for a 16 x 48 driftboat oars. My project is 18 foot with an 80 inch beam. I have purchased 1 and 15/16… Started by Steve Sobba in General Forum |
2 |
Jun 23, 2009 Reply by Steve Sobba |
Anyone build a freestone classic from Montana Boat Buiders?I have decided to go that route and now I am waiting for the plans. Anyone have any input on building that model. I went with the 15', plan… Started by Joseph Podesta in General Forum |
1 |
Jun 22, 2009 Reply by Jason Knight |
KevlarI am going to build a stich and glue 14' drifter. I want to build a boat that does not wiegh a ton but is very strong and has a reinforced… Started by Joseph Podesta in General Forum |
13 |
Jun 20, 2009 Reply by Randy Dersham |
Closer...Ok - So have the decided that I wanted to varnish the exterior of hull instead of paint. I have managed a few coats and learned a bit about… Started by Jason Knight in General Forum |
14 |
Jun 19, 2009 Reply by Steve Sobba |
Kevlar^2I'm back. I have been doing some additional research and it appears I am reaching a decision point roughly in line with Kevlar methodology… Started by Jonathan in General Forum |
0 | Jun 17, 2009 |
American Angler MagazineFYI - In the new "American Angler" magazine there is a 2 page spread on river dories/drift boats. It's a pretty light article but I thought… Started by Jason Knight in General Forum |
0 | Jun 15, 2009 |
New boat hits the waterHere are a few photographs of the 17x52 McKenzie Inline Convertible. This is the same boat the Jason K. is finishing up right now. it's mad… Started by Randy Dersham in General Forum |
8 |
Jun 14, 2009 Reply by Mark Griffith |
New Bottom and Chine on an Old BoatAfter much deliberation (and procrastination) my Dad and I finally ripped, sawed, pried, hammered, cussed, tore, cussed, ground, drank and… Started by Robb Grubb in General Forum |
2 |
Jun 14, 2009 Reply by Robb Grubb |
© 2025 Created by Randy Dersham.
Powered by
