Rookie getting started with a Rapid Robert

I purchased Rogers book about 6 months ago and decided on a Rapid Robert for my first build.  A lot of reading and as soon as I started laying out frames I came up with a question.

For the side frame pieces, on page 226 it mentions they are to be tapered to 1-1/4 at the sheer and 2-1/2 at the base.  I am assuming the dimension is measured 90° from the long edge, but from what point on the beveled edge?  From the widest side of the frame (i.e. measured before the bevel is cut), or the narrowest at the edge of the bevel (after the bevel is cut)?

Any input is greatly appreciated.  I have worked as a cabinetmaker/custom door builder - so making the cuts and bevels is not an issue - just want to make sure I have the measurements correct.

Thanks,

Views: 444

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Witton on July 1, 2016 at 3:10pm

I measured from the short point of the bevel, giving the frame more meat - although I'm not sure it matters as long as you're consistent. 

Permalink Reply by Stan Foy on July 1, 2016 at 3:17pm

David,

  Thanks for the input.  I just put together one frame to figure out the order of the cuts/bevels, I have some additional planning to do. :)

Permalink Reply by Mike Baker on July 1, 2016 at 4:53pm

Stan,

It doesn't matter on the bottom. If you are using 1x4 I just get as much meat as I can. If having them consistent is an issue for you then build the frame/rib with the most bevel (likely the front most one) first as it will be the narrowest cuz of the bevel then use that measurement for the rest.

Mike

http://www.bakerwooddriftboats.com/

Permalink Reply by Stan Foy on July 3, 2016 at 7:59am

So far so good.  Hope to have all the frames done this weekend.  Thanks for the input above.

Permalink Reply by Mike Thomas on July 3, 2016 at 4:15pm

Exciting!! it will be fun to watch the build

Permalink Reply by Stan Foy on July 3, 2016 at 5:21pm

Thanks Mike, it is going a bit faster than I thought it would.  Have all 6 frames done and got a start on the transom today.

Permalink Reply by Greg Hall on July 3, 2016 at 7:36pm

Looking forward to watching your progress Stan.  I ordered Rogers book and decided to build a Rapid Robert too.  I have the lumber for my frames ordered.  It's supposed to arrive Tuesday and I will be starting mine.

Greg

Permalink Reply by Stan Foy on March 14, 2017 at 4:26pm

Unfortunately, life kinda got in the way of the build.  Weather is starting to warm up so I hope to get back to it before long.

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service