Chine notch angles

I'm currently building a Don Hill 17Flyfisher.  I have all the frames completed and about ready to cut the notches for the chine logs.  The plans say to notch the frames parallel to the sides and bottom, and to cut a 25deg bevel on the top and bottom of the chine logs.  Since most of the frame angles are different this will result in gaps at the top of some of the chine logs.

How do you guys cut your chine notches?  Do you cut them parallel to the bottom frame and live with the gap, or do you account for the bevel on the chine?

Views: 32

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Witton on Wednesday

The bottom has rocker, is curved, so the bevel at the bottom of each frame is different, increasing towards the bow and stern. The cut in the side of the frame should be parallel to the bottom of the frame - if so, there will be no gap at the top of the chine log. 

Permalink Reply by Art Page on Wednesday

Maybe I'm not following, but the plans call for a constant 25deg bevel at the top of the chine.  This implies there is a corresponding constant 25deg bevel at the mating surface on each chine notch, which isn't true.  The end result would be a slight gap on some of the notches.  I believe it's the rib angle (splayed out from vertical) that is different on most of the frames that's the offending culprit, not the rocker angle.

I ended up tracing the outline from a cross-section of the chine log and cutting to those lines, as shown in photo.

RSS

© 2025   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service