Hi everyone, I'm just getting started.  I've gathered all the tools, read Fletcher's book about 6 times (so great), and read quite a lot of these posts (also great).  I've decided to build a 17x54.  Went to the lumber dealer in town, and decided i'm definitely going to use the Hydrotek BS 1088 6mm for sides, and 12mm for floor.  I'm going to use Mahogany for the Stem.  I'm planning to use Port Orford Cedar for the frames, and was thinking i'd match that with White Oak for the rails/chines.  I hope to have the boat for the rest of my life, and while i want it to be the most beautiful boat ever built, I truly want to use materials that will last and be effective.  So, first question... Instead of White Oak, anyone ever use Port Orford for rails?  It seems like the color would be similar to White Oak, but i wonder about durability as a rail.  appreciate any insight you might have.

Views: 10531

Reply to This

Replies to This Discussion

thanks Dorf.

I'm going to use silicone bronze ring nails to hold the outside rail on, what should i bed it with?  Seems like 5200 is overkill here.

I used life caulk. You want something that can be pulled off easier down the road for repairs

Not sure you'd even need to bed it - I didn't, and this area sees so little water it's all good so far. 

Got a little more work done the past couple days.  Installed the outside sheer rail:

I have a question.  One of my frames has the bevel slightly off which created a gap on one side. (see images below).   I'm concerned if I leave the gap it may put uneven force on that frame and cause it to fail. Should I try to fill this in with thickened epoxy? 

Can you plane it to fit better? It almost looks twisted which won't be good long term.

Rick Newman

^^

Your bevel fits down at the chine log.  The bevel has to roll slightly as the panel twists at a different angle from chine to sheer.

Or add a shim.  I try to avoid large epoxy fills--it runs out too easily, it's heavy, it's rigid (doesn't flex like wood), it's expensive.

I don't know how i'd accomplish the roll of the bevel at this point... I'm thinking shim may be my best bet.

it isn't twisted.  I sure wish I could plane it, but its nailed and epoxied.

You could always get a deep clamp or two and squirt a little dab of thinkened epoxy in there. These work well for me

RSS

© 2024   Created by Randy Dersham.   Powered by

Badges  |  Report an Issue  |  Terms of Service